\"

Agenda Day 2

8:50 AM - 9:20 AM Registration and welcome coffee


img

Dipl.-Phys. Reinhard Sottong

Research Associate, Thermoelectric Materials and Systems
German Aerospace Centre (DLR), Institute of Materials Research
  • Introduction about Vapour Adsorption refrigeration cycle
  • Modelling and sizing of POC (Proof of Concept)
  • POC Testing
  • Validation and Summary

img

Dr. Ajit Kumar Jindal

Vice President and Head Technical, Commercial Vehicles, Engineering Research Center
Tata Motors
img

Sivakumar Palanivelu

Assistant General Manager, Engineering Research Center
Tata Motors
  • Value vs on-cost of exhaust thermal management solutions
  • Quantifying the best options where waste heat can be applied to maximize the Value-to-Cost-ratio
  • Advantages of reduced fuel costs, higher economy and emissions

img

Dipl.-Phys. Reinhard Sottong

Research Associate, Thermoelectric Materials and Systems
German Aerospace Centre (DLR), Institute of Materials Research
img

Thomas Reiche

Research Engineer, Waste Heat Recovery
VOLVO
img

Guillaume Hébert

R&D Manager EGR & Exhaust Thermal Management
Hanon Systems

10:50 AM - NaN:NaN AM Morning refreshments and networking

11:20 AM - 12:00 PM Potential and challenges for HD Truck waste heat recovery

Thomas Reiche, Research Engineer, Waste Heat Recovery, VOLVO
  • Introduction
  • Rankine cycle architectures
  • Potential estimation
  • Challenges for market introduction

img

Thomas Reiche

Research Engineer, Waste Heat Recovery
VOLVO

12:00 PM - 12:40 PM Efficiency increase by electrical/thermal recuperation in automotive

Michael Decker,, Leading Technical Expert, Thermal Management of ECUs, Continental AG
  • Recuperation case study for commercial vehicles
  • Lack of heat in electrical vehicles and range increaseby use of thermal recuperation
  • Recuperation limiting factors a) electrical b) thermal

img

Michael Decker,

Leading Technical Expert, Thermal Management of ECUs
Continental AG

12:40 PM - 2:10 PM Networking luncheon

  • Biggest problem of electromobility: limited range, high initial cost
  • Heating in summer and cooling in winter can reduce maximum driving range by 50%
  • Solution: increase energy efficiency; maximize range of existing vehicles by means of thermal recuperating strategies
  • Introduction to different thermal recuperation strategies
  • Analysis and evaluation of the impact of the proposed strategies using entire vehicle simulation

img

Dominik Dvorak

Scientist, Center for Low-Emission Transport, Electric Drive Technologies
AIT Austrian Institute of Technology
img

Hansjörg Kapeller

Researcher, Center for Low-Emission Transport, Electric Drive Technologies
AIT Austrian Institute of Technology
  • High figure-of-merit n-type material development
  • Ways to improve p-type Mg2Si-materials
  • Contact development for Mg2Si-based thermoelectric modules

img

Dipl.-Phys. Reinhard Sottong

Research Associate, Thermoelectric Materials and Systems
German Aerospace Centre (DLR), Institute of Materials Research

img

Dipl.-Phys. Reinhard Sottong

Research Associate, Thermoelectric Materials and Systems
German Aerospace Centre (DLR), Institute of Materials Research